Rs Internal Battery 540Wh Diagnostics (Information For Dealers) - Orbea BLUE PAPER RISE Manual Tecnico

80 | ORBEA
RS INTERNAL BATTERY 540Wh
DIAGNOSTICS
(Information for dealers)
The Orbea RS 540Wh internal battery does not have LEDs
to display error codes in the battery, and it is not diagnos-
the Rise H electric system, use Etube Professional to rule
out that the problem does not come from other of the
Contact Shimano to provide them with a system report
comes from the internal battery, contact Orbea through a
RS INTERNAL BATTERY REMOVAL
(Information for Orbea dealers)
The installation and replacement of the electric
system components requires an advanced tech-
nical knowledge and may therefore be beyong
Always take your bicycle to an authorized dealer
for the diagnosis, repair and installation of the
Damage to the components derived from incor-
rect installation may void the warranty on such
TECHNICAL MANUAL
Orbea recommends that only authorized dealers
perform the removal and/or replacement of the
to remove and install important components of
remove the internal battery for transportation,
always take your bicycle to an authorized dealer to
avoid damaging the components and ensure their
An incorrect installation of the electric compo-
nents can damage them, which can cause them
to malfuntion and create a risk of accidents and
B LUE PAP ER R I SE · HYDRO 2022
2.5
1. Remove the right crank arm following the manufacturer
E-Thirteen Plus EP8 Cranks:
-
cles/360058908731-Shimano-E-spec-Crank-Manual
Shimano FC-EM900/FC-EM600 Cranks:
2. Remove the top part of the chainguide to allow the
5.
4
4
2
3
1
3.
It is necessary for the rear wheel and the chain to be
installed on the bike to allow you to lock the chainring
by holding the rear wheel in place and thus allow you to
Use the Shimano TL-FC39 and TL-FC33 tools to remove
4. Remove the chainguide bracket to gain access to the
- 6
6
5
6
6
ORBEA | 81
E N
6
6