Pedelec System Updates; After A Crash Or An Impact - Orbea BLUE PAPER RISE Manual Tecnico

14 | ORBEA
Read the Warnings of Use and the Relevant
information about the RS batteries sections
of this manual to know about the correct

PEDELEC SYSTEM UPDATES:

The ebike systems manufacturers may develop improve-
ments and updates of their pedelec systems over time that
Some updates in the STEPS system can be performed by
the end consumer via Bluetooth® connecting the bicycle
When performing a system update via Blue-
tooth® using the Shimano Etube Project mo-
bile app, it is recommended to disable all the
to avoid that an incoming call or message
In case the update is interrupted and this
causes any malfunction in the system, take
your bicycle to an authorized Orbea dealer
to complete the update using the SM-PCE02
Read here the Etube Project app manual:
Remind your dealer to check for available updates when
TECHNICAL MANUAL
Some of these checks and maintenance
needs go beyond the mechanical knowledge
always visit an Orbea dealer for maintenance
failure to perform proper maintenance can
result in malfunctions and accidents with se-
Incorrectly performed maintenance can dam-
age the components, which are not covered
R E PLAC E ME N T PA RTS
Always use original Orbea or Shimano replacement parts
The use of non-original replacement parts may
cause damage that results in malfunctions
The installation of some of the replacement
parts in this technical manual are beyond
the mechanical knowledge of most bicycle
replacement parts, always visit an Orbea
dealer for maintenance on your bicycle and
replacement parts can result in malfunctions,
The installation of non-original replacement
parts can damage your bicycle and is not
B LUE PAPER RIS E · H YD RO 2022

AFTER A CRASH OR AN IMPACT

-
dent on your Orbea bicycle, be sure that you're okay and
should check the condition of your bicycle before contin-
INSPECT THE FRAME AND THE BICYCLE COMPO-
NENTS TO SEE IF THEY HAVE BEEN DAMAGED IN
ANY WAY.
If you detect any problem, do not continue to ride the
POINTS TO CHECK
Inspect the frame and the fork to identify whether either of
any damage or cracks, you must stop using the bicycle im-
The materials used on carbon frames and
forks are rigid and strong, but if overloaded
impact to this material could cause damage
case of any doubt about the consequences of
a fall or accident, contact your Orbea dealer
Check the drivetrain and the wheels to make sure that the
Even if you do not observe any damage, pay close atten-
-
If you notice any unusual noise, stop using your bicycle
immediately and contact your Orbea dealer for a correct
TAKE YOUR ORBEA BICYCLE TO AN AUTHORIZED
DEALER FOR A PROFESSIONAL INSPECTION
Some of the consequences of a fall or accident can only
be detected by completely disassembling the bicycle
to check for the presence of damage or other signs of
A collision or impact can cause serious dam-
age to your bicycle and its components,
causing them to malfunction or wear out pre-
and without notice, causing you to lose con-
trol of your bicycle and suffer serious injuries,
ORBEA | 15
EN