Using Orbea Rs Toolboxx - Orbea BLUE PAPER RISE Manual Tecnico

38 | ORBEA
3.
4.
If you had not connected your bicycle before setting up
Toolbox on your device, the unit will show the message
"Searching..." after selecting the Orbea RS Toolbox
the page where you chose to see Toolbox, the data from
TECHNICAL MANUAL
Garmin Edge units
Garmin watches
Garmin Edge units
Garmin watches
B LUE PAP ER R I SE · H YD R O 2022
5.
which you selected to see the data from Toolbox or start
USING ORBEA TOOLBOX
Orbea RS Toolbox is not compatible
with the use of the Garmin Edge Shima-
no STEPS native app on Edge 530, 830,
1030, and 1030 Plus devices. Disconnect
or delete your bicycle from the sensors list
of your Edge unit before trying to connect
CONNECT YOUR RISE TO ORBEA RS TOOLBOX
Always turn your Garmin on and start recording an activity
and then turn your bicycle on for the remaining battery
Otherwise, the remaining battery level will be displayed
when some distance has been covered and the battery
When starting Toolbox, it will connect to the bike with the
strongest signal (normally the closest one) and, once con-
encing pairing problems, make sure your Rise is the only
Garmin Edge units
Garmin watches
-
ORBEA | 39
E N