GM 19155533 Instrucciones De Instalación

Rear Fascia Closeout (Hitch Cover)
Kit Contents
Rear Fascia Closeout (Hitch Cover)
Push Pin Quarter Turn
Push Pin Retainer
Attachment Bracket
Drill Template
Installation Instructions
Tools Required
Drill
Center Punch
3/8" (9.5 mm) diameter drill bit
Scotch Tape
Drill Template
Installation Instructions
1. Align drill template's profile side with the profile of the
fascia.
a. Secure drill template with scotch tape into position.
2. Ensure that the edge of the drill template matches to the
back trim edge of the fascia. Align attachment bracket to
fascia profile to check hole locations.
3. Mark holes using a center punch.
4. Drill the three holes using a 3/8" (9.5 mm) diameter drill bit.
5. Secure the attachment bracket to fascia by using the 3
push pins retainers.
Rear Fascia Closeout (Hitch Cover)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 07DE05 I
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
2
3
1
1
1
REVISION AUTH
6. Align hitch cover locator tabs with the opening in the attach-
ment bracket.
7. Press hitch cover onto fascia and move cover gently to the
left to engage locator tabs in the attachment bracket.
8. Slide hitch cover to the left until the rectangular holes of the
cover are lining up with the rectangular holes in the bottom
of the fascia.
9. Install the two push pin quarter turns, into the rectangular
holes – slotted at bottom.
a. Rotate the push pin quarter turns to lock in place.
10. Ensure cover is attached securely.
IR 07DE05
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Rear Fascia Closeout (Hitch Cover)
PART NO.
19155533
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19155533
SHEET
1
SHEET
1
3
OF
3
OF