GM 19155506 Guia De Inicio Rapido

Vehicle Cover – Snugfit
Contents:
Description
Vehicle Cover
Storage Bag
Grommet
Congratulations! You have purchased the finest vehicle cover
available. We appreciate your commitment to keeping your vehicle
in the best possible shape. By following these instructions you will
realize maximum effectiveness and longest life from your vehicle
cover. Please read and follow these carefully.
Warning
• Never use this cover on your vehicle after your vehicle
has been painted within the last three months. The paint
must cure completely for this period of time prior to
installing your cover.
• Do not cover your vehicle when your vehicle is in-tow or
when your vehicle is towed on an open flat-bed trailer.
• Never expose you vehicle to high winds with the vehicle
cover installed.
• Do not install the cover on a wet vehicle when the
temperature is below freezing as the cover may freeze
onto the vehicle.
Failure to observe these warnings will result in damage to
your vehicle.
Important notes:
• A vehicle cover locking cable, part number 12344218, is
available from your vehicle dealer to secure your cover
from theft.
Corvette Vehicle Cover
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
07OC05 I
WHITE 16 POUND NON-BOND
M
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
Quantity
1
1
1
REVISION AUTH
1. Installing Your Vehicle Cover – Once the engine has been
turned off, allow the vehicle to cool for at least 20 minutes
before installing your cover. Look for the tag labeled 'front''
sewn into the hem to locate the front of the vehicle cover.
Place the cover on the hood and roll it back across the roof
until completely unrolled. Slip the antenna opening over the
antenna if applicable.* Fold the cover down each side of the
vehicle and then over the trunk and hood. Hook the elastic
under the front and rear bumpers.
Caution: Do not place cover near hot mufflers or
exhaust pipes.
2. Removing Your Vehicle Cover – Remove the cover from the
rear bumper and fold up about two feet of material toward
the roof. Repeat this process with the front of the vehicle.
Fold each side onto the roof. Continue until you have approxi-
mately an 18" strip of cover over the center of the vehicle.
Roll the cover tightly and store it in the provided storage bag.
3. Care and Cleaning – Your vehicle cover is made of Snugfit
material which is a knitted polyester fabric. This fabric is
intended to cover your vehicle when stored in a garage only.
If an area becomes soiled, use an all-purpose cleaner to rub
it out, and rinse the area with water. Do not machine wash.
Do not machine dry. Air dry only.
* Note: You may either remove the antenna prior to installing the ve-
hicle cover or install the grommet provided to accommodate
the antenna. To install the grommet, locate the point at which the
antenna will pass through the cover and mark with an "X". Using a
sharp knife, cut the shape of the "X". Both cuts should not exceed
3/4 inch (19mm). Place one half of the two piece grommet on one
side of the "X" with the second half on the opposite side. Snap the
two halves together.
IR 07OC05
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Vehicle Cover
PART NO.
19155506
6200 Grand Pointe Dr., Grand Blanc, MI 48439
1
19155506
SHEET
1
SHEET OF
3
OF
3