GM 22879302 Guia De Inicio Rapido

Installation Instructions:
Please read all instructions before proceeding.
Tools Required:
#20 Torx Driver, Electric Drill, Center Punch.
It is recommended that 2 people are used to install the bed liner. Make sure the truck box and bedliner are clean prior to
installation. Do not allow the bedliner to contact the bedrail surfaces. Mask or cover the side rails at the top and inside surfaces
to prevent scratches or damage during installation.
UNDER RAIL BEDLINER
LIFT AT CENTER
P/N 12490553
PRE-DRILLED
SLOTTED HOLES
(5 LOCATIONS)
Bed Liner and Tailgate Liner
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Bed Liner and Tailgate Liner
1. Place bedliner in truck box. While standing beside truck at approximately the center
of box area, lift side of bedliner up at a 45 degree angle so that the opposite side slips
under the side-rail of pickup truck. A second person may be required to help slip the wall
of the bedliner under the sidewall of the truck box.
2. 6WDQG DW WKH UHDU RI SLFNXS FHQWHU DQG OLIW WKH FHQWHU RI EHGOLQHU ÀRRU XS +DYH D VHFRQG
SHUVRQ SXVK EHGOLQHU ZDOO XQGHU VLGHUDLO RI WKH SLFNXS WUXFN 5HOHDVH EHGOLQHU ÀRRU
3. Make sure bedliner is all the way forward in truck box and centered. Press the front wall
RI EHGOLQHU ¿UPO\ DJDLQVW IURQW ZDOO RI WUXFN ER[ &HQWHU D VHOIGULOOLQJ VFUHZ LQ WKH FHQWHU
(No. 1) pre-drilled hole in front wall of bedliner. Fasten the screw to the truck box wall with
a power screwdriver. DO NOT OVER TIGHTEN BECAUSE THE SCREW THREADS
CAN BE STRIPPED EASILY.
AUTH
REVISION
PART NO.
REV 25MR13
INSTALLATION INSTRUCTIONS
DR
TITLE
Bed Liner and Tailgate Liner
PART NO.
22879302
6200 Grand Pointe Dr., Grand Blanc, MI 48439
22879302
SHEET
1
SHEET
1 9
OF
9
OF