Chicco Fun & reLax Manual De Instrucciones página 11

2. ASSEMBLING THE TOY IN CUDDLER MODE
1. Completely unroll the netted fabric stored inside the lining (Diag. F-1), attach it to the activity arch
and use the velcro fasteners on the arch to fix it in place, as seen in Diagram F-2.
2. When the cuddler is assembled correctly, it should look like the one shown in Diagram F-3.
3. ASSEMBLING THE TOY IN ACTIVITY MAT MODE
3.1 Remove the netted fabric from the frame comprising the activity arch and arch support, folding it
away inside the lining as seen in Diagram G-1.
3.2 Release the strap that fastens the arch support to the activity arch (Diag. G-2) and accompany the
latter with your hand into a horizontal position, as seen in Diagram G-3.
3.3 Place the arch support under the outer lining, as seen in Diagram G-3.
4. HOW TO FOLD UP THE TOY
4.1 Lift a section of the toy upwards to a vertical position and, at the same time, press the buttons on
the side of the arch structure one at a time, making sure they all remain tightly closed (Diag. H-1).
Fold both sides together as seen in Diagram H-2.
4.2 Now zip it up all the way round to create a bag as before (Fig. H-3).
5. REMOVING AND ATTACHING THE HANGING TOYS ON THE ACTIVITY ARCH
5.1 Removing the toys: open the velcro fastener (Diag. I – 1), unthread the strap through the activity
arch slot and remove the hanging toy. Repeat this procedure for the second hanging toy. The hang-
ing toys can now be used a rattles.
5.2 Attaching the toys: thread the strap through the hanging toy hook (Fig. I – 2). Now thread the strap
though the slot on the activity arch (from the bottom upwards) (Fig. I – 3.1) and use the velcro fas-
tener to fix it in place (Fig. I – 3.2). Adjust the hanging toys to the right height for your baby.
HOW TO USE THE TOY
Switching it ON and Off
• To switch the electronic panel ON (Diag. L), move the switch (L.1) from the 0 position to the I position
(Relax) or II (Fun) position according to the play mode desired.
• To adjust the volume level, move the switch (L.2) to <)) (low) or <))) (high).
• In order to avoid using up the batteries for no reason, it is recommended to switch off the toy by moving
the switch to OFF when not in use.
2 PLAY MODES:
1. RELAX - move the switch from the 0 position to the I position; the toy will automatically start playing
soft music and light effects to soothe the baby. The hanging toys do not trigger the sound effects and
tunes when the toy is in this mode. The toy will switch off automatically after 10 minutes. To start it
again, move the switch to the play mode desire. It is recommended to use this play mode when the toy
is being in nest mode;
2. FUN - move the switch from the 0 position to the II position; a tune will start playing automatically.
Every time your baby touches the hanging toys or the arch with his hands, this will trigger different
sound effects along with the tunes. When the tune finishes, the baby can make it play again by touching
the hanging toys or the activity arch. The toy will automatically switch to stand–by mode if the toy is not
touched for over 60 seconds. Simply touch the hanging toys or the arch to enable the toy activities again.
It is recommended to use this play mode when the toy is being used in gym and playmate mode
11
.