Silvercrest SMBC 30 A1 Manual De Instrucciones E Indicaciones De Seguridad página 48

SilverCrest SMBC 30 A1
Keep the Play/Pause button [6] on the Micro Stereo System or the
Play/Pause button [50] on the remote control pressed to toggle the
increments from 0.1 MHz to 0.05 MHz. Repeat this procedure to toggle the
increments back to 0.1 MHz. "50KHZ" or "100KHZ" will appear on the
display [2].
Saving a station manually
You can save up to 30 stations. Proceed as follows:

Tune in the station that you want to store.

Press the PRO button [13] on the Micro Stereo System or press the PRO button [41] on
the remote control.

The currently selected preset flashes on the display [2].

Press the ▲ button [9] or the ▼ button [10] on the Micro Stereo System or the ▲ button
[52] or ▼ button [48] on the remote control to select the preset where you want to store the
station.

Press the PRO button [13] on the Micro Stereo System or press the PRO button [41] on
the remote control to save.
Please note that any station presets used will be overwritten.
Recalling a saved station
Proceed as follows to recall a saved station:

Press the ▲ button [9] or the ▼ button [10] on the Micro Stereo System or the ▲ button
[52] or ▼ button [48] on the remote control to toggle between the saved stations.
or

Press the numeric buttons [30] to select a saved station directly.
Stereo/Mono operation
You can receive stations in Stereo or Mono. Press the MOD button [14] on the Micro Stereo
System or press the Stereo/Mono button [42] on the remote control to toggle between stereo
and mono reception. "STEREO" or "MONO" is briefly shown on the display [2].
9.6. CD
Switch the Micro Stereo System on and press the Operating mode button [16] multiple times
until the display [2] reads "DISC", or press the CD button [33] on the remote control.
If no CD has been inserted into the CD tray [1], the display [2] reads "NO DISC".
46 - English