Beko DRYPOINT M PLUS Instruciones De Instalación Y De Servicio página 2

5
english
. Liability for defects
Please read this information very carefully:
Liability for defects can only be accepted if the following
rules and the instructions for installation are complied
with.
Provided appropriate CLEARPOINT filters are being
used and the filter elements are replaced once a year,
the purchaser of the compressed-air membrane dryer
shall be entitled to claim remedy of defects within 2 years
from date of invoice.
BEKO shall not be liable for damage due to improper
or incorrect use, wear, storage or other actions by the
purchaser or third parties.
This applies in particular to wearing parts.
. Temperature
There must be no danger of frost at the place of instal-
lation; the temperatures at the place of installation and
of the compressed air should be between +35 and
+140 °F.

Important information • Indicaciones importantes
5
4
6
3

4
5
4
6

3 : integrated Nano filter
3. Filters
Please observe the relevant filter requirements (see
page 8 - 9):
Dirt particles, oil residues and liquid condensate have
to be safely retained.
For these purposes a CLEARPOINT nanofilter N (0,01µ)
is integrated in the membrane dryer housing. With high
dirt loads or large amounts of condensate, it will be ne-
cessary to install a CLEARPOINT F fine filter (1 µm) in
addition and, where appropriate, a W water separator.
Note: The filter elements need to be replaced once a
year.
This applies for the replacement of the nanofilter as well
which is an integrated part of the membrane dryer:
- Remove bottom part of the membrane dryer housing
(fine thread). In doing so hold the upper part tight in
its position.
- check the float drain and replace it, if required
(FAD055)
- Exchange the filterelement and reassemble the two
body parts and screw tight
DRYPOINT DM 40-61 C-N, 40-75 C-N, 40-90 C-N
5
Nanofiltro integrado