SOUNDMASTER IR5500 Manual Del Usuario página 13

Network configuration
1. Normal network configuration
 Select "Yes" for the normal Wireless Network Configuration: Then select the required AP
by turning "NAVIGATE/OK" and confirm it by pressing "NAVIGATE/OK".

Enter WEP or WPA code to connect the WiFi network by select the correct character
turning the "NAVIGATE/OK" button.
Press ">" button to select the next character.

 In this condition, press "<" button you can turn left and delete the left characters at the
same time:
 When the password is complete please press "NAVIGATE/OK" button to confirm.
Note: Below characters are available for the radio:
2. WPS PBC network configuration
 Select "Yes WPS" when you would like set up with Wireless Network (WPS PBC) feature:
If you are using a router with WPS button, you may set up the network connection simple
via WPS function. Enter it and go to press the WPS button on your router within 120
seconds.

The connection between the router and the Radio will then be configured automatically
 Select "No" when you not want to install the network at the moment.
3. No network configuration
 Pls. select "No" when you don't like to configure the network connection at the moment.
Press " " for standby, when the actual date and time is shown the network is configuration is
well done. Date and time, as well as alarms-if activated-will still are shown on the display when
in standby mode.
Numbers(from 0-9)
English letters(from A to Z and from a to z)
Other characters (@,!,",#,$,%,&,*,',+ and (,)
IR5500 / English Instruction Manual
2