Power Supply; Important; Operation - THOMSON TDW 1445 Manual De Instrucciones

Drain hose
Insert the drain hose into a drainage pipe or standpipe.
The end of the hose should be dropped into a drainage pipe, the maximum height of which
should be 1000 mm above the base of the dishwasher. The end of the hose must not be
immersed in water to avoid the back flow.
To allow for an air gap around the end of the drain hose, the diameter of the standpipe
should be at least 40 mm.
If leaks are detected, immediately shut the water supply and check the hose connections
fully. Re-tighten the connections if necessary.
If for any reason you are unable to stop the leak yourself please seek advice from a
qualified plumber.

POWER SUPPLY

IMPORTANT:

The mains socket must be accessible at all times.
Do not connect an extension lead to the appliance to avoid potential safety hazards.

OPERATION

Your dishwasher cleans by spraying a mixture of clean water and detergent (under
pressure) against the soiled surface of dishes. The water is pumped through rotating spray
arms, drained through a filter removing food and soiled particles, and pumped back
through the spray arm.
Soiled water is pumped out and replaced with clean water at the end of each cycle (the
number of times depends on the cycle being used).
6