Starting The Dishwasher - THOMSON TDW 1445 Manual De Instrucciones

STARTING THE DISHWASHER

1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
Ensure they are clean and properly positioned. See "Cleaning and maintenance"
section.
4. Check that there is rinse aid and salt.
5. Load the dishes.
Ensure that the spray arms can rotate freely.
6. Add the required amount of detergent into the dispenser according to the "Washing
Programmes" chart.
7. Close the dishwasher door securely.
8. Press to switch the dishwasher on.
The ECO programme indicator light will illuminate and the display will show the
washing time.
9. Select the desired washing programme by repeatedly pressing
corresponding washing programme indicator light illuminates.
Delay timer: The delay timer allows you to delay the start of a washing programme
by up to 24 hours.
Repeatedly press
for a 3-hour delay.
Once the delay timer has been set, press
10. If you want to perform a half load wash, press
light will illuminate.
The function can only be used in Intensive, Normal, Eco, Glass and 1 Hour
programmes.
When this function is activated, the dishwasher will automatically reduce the water
and energy consumption and the washing time.
11. Start the washing programme by pressing
work.
12. At the end of the washing programme, the dishwasher will buzz and automatically
stop.
13. Wait for about 15 minutes before you open the dishwasher door in order to avoid
burns.
14. Unload the dishes.
The washing cycle will not start if the dishwasher door is left open or not properly
closed.
Do not open the door when the dishwasher is working since hot water may be
ejected which could cause scalding.
until the desired start delay is shown on the display, e.g. H:03
1/2
to activate the function.
and the half load function indicator
. After a few seconds, the machine will
until the
15