Rechargeable Battery Pack; Troubleshooting - DeWalt DCS355 Traducido De Las Instrucciones Originales

Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
reached the end of their working life. To take
advantage of this service please return your product
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Unit will not Battery not
start. installed
correctly.
Battery is not
charged.
Battery or
power tool is
overheated.
Switch is
damaged.

Rechargeable Battery Pack

This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• Li-Ion cells are recyclable. Take them to your
WALT
E
dealer or a local recycling station. The collected
battery packs will be recycled or disposed of
properly.
POSSIBLE SOLUTION
Install battery in tool handle and ensure it is seated correctly.
Place battery on charger and install a fully charged battery pack in
tool.
Allow battery and/or tool to cool after extended use or replace
overheated battery pack with a cool one.
Have switch replaced by an authorised D
ENGLISH
WALT repair agent.
E
45