Helpful Hints - DeWalt DCS355 Traducido De Las Instrucciones Originales

2. Insert screw (o) and washer (u) into the dust
extraction adaptor (q) and tighten with the
supplied hex key (p).
OPERATION
Instructions for Use (fi g. 14, 15)
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
WARNING: Ensure switch is fully OFF
before installing the battery.
1. Install the battery pack.
2. To turn the tool ON, hold it as shown in
figure 14 and press the variable speed
trigger (a).
NOTE: The further the trigger switch is
depressed the faster the tool will operate.
If in doubt about the proper speed for your
operation, test the performance at low speed
and gradually increase until a comfortable
speed is found.
3. To turn the tool OFF, release the variable speed
trigger (a).
Lock on/off Button (fi g. 15)
The tool can be locked off by fully depressing the
lock on/off button (d) shown in figure 15.
For more comfort in extended use applications, the
lock on/off button (d) can lock the trigger trigger (a)
in the depressed position.
LED Worklight (fi g. 16)
The LED worklight (b) will activate when the trigger
is depressed. It will automatically shut off following a
short period of time once the trigger is released.
Proper Hand Position (fi g. 14)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires the tool to be held as
shown in figure 14.
Using the Dust Extraction Adaptor
with the Sanding Platen (fi g. 18)
1. Attach the dust extraction adaptor (q). Refer to
Attaching the Dust Extraction Adaptor.
2. Attach the sanding platen (w) as described
under Installing/Removing Accessories.
3. Attach sanding sheet as described under
Installing/Removing Sanding Sheets.
Using the Dust Extraction Adaptor
with Plunge Cutting Accessory
(fi g. 19)
1. Attach the dust extraction adaptor. Refer to
Attaching the Dust Extraction Adaptor.
2. Push dust extraction arm (s) into the lower
aperture of the dust extraction adaptor (q).
3. Attach plunge cutting blade as described under
Installing/Removing Accessories.
4. Adjust the dust extraction arm (s) for best
results.

Helpful Hints

• Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement
of the material may affect the quality of the
cutting or sanding finish.
• Do not start sanding without having the
sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for
the finishing surfaces. If necessary, first make a
test run on scrap material.
• Excessive force will reduce the working
efficiency and cause motor overload. Replacing
the accessory regularly will maintain optimum
working efficiency.
• Do not allow the sandpaper to wear away, it will
damage the sanding pad.
• If the tool overheats, especially when used at
low speed, set the speed to maximum and
run it with no load for 2–3 minutes to cool
the motor. Avoid prolonged usage at very low
speeds. Always keep the blade sharp.
ENGLISH
43