DeWalt DWE4884 Traducido De Las Instrucciones Originales página 33

WARNING: Do not use accessories
with a mandrel length exceeding
40 mm. Ensure that the exposed
mandrel length is no more than 10 mm
after inserting accessory into collet.
WARNING: Never tighten the collet nut
without an accessory in the collet.
1. Hold the spindle (b) using the 13 mm wrench (d)
provided.
2. Loosen the collet nut (c) with the 17 mm
wrench (e) by turning it counterclockwise.
3. Insert the shank of the accessory (minimum
20 mm) into the collet.
4. Securely tighten the collet nut (c) using the
spanner provided.
NOTE: The shank overhang, amount that sticks
out past the collet nut (c), should not exceed
10 mm. Refer to figure 4.
To remove the accessory, proceed in reverse order.
Metal Applications
When using the tool in metal applications, make
sure that a residual current device (RCD) has been
inserted to avoid residual risks caused by metal
swarf.
If the power supply is shut off by the RCD, take the
tool to authorised D WALT repair agent.
E
WARNING: In extreme working
conditions, conductive dust can
accumulate inside the machine housing
when working with metal. This can
result in the protective insulation in the
machine becoming degraded with a
potential risk of an electrical shock.
To avoid build-up of metal swarf inside the machine,
we recommend to clear the ventilation slots on a
daily basis. See Maintenance.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
Motor Brushes
Keep brushes clean and sliding freely in their guides.
Carbon brushes have varying symbols stamped
into them, and if the brush is worn down to the line
closest to the spring, they must be replaced. New
brush assemblies are available at your local service
center.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. This product must
not be disposed of with normal
household waste.
ENGLISH
WALT, have
E
31