Memorizing The Adjusted Channel Levels - Sherwood RD-606i Instrucciones De Funcionamiento

RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 21

Memorizing the adjusted channel levels

• You can memorize the adjusted channel levels into preset
memory("REF 1", "REF 2") and recall the memorized
whenever you want.
1.
After performing the steps 1 ~ 4 in "Adjusting the
current channel level" procedure on page 20,
press the ENTER(/MEMORY) button.
ENTER/MEMO
MODE
V I D E O 1
• Then "1" of "REF 1" indication flickers for several seconds.
2.
Select the desired one of REF 1 and REF 2.
TUNE
• If the preset memory disappears, perform the above step
1 again.
3.
Confirm your selection.
ENTER/MEMO
• The adjusted channel levels have now been memorized
into the selected memory.
AT HDMI
: R E F 1
( HDM I 1 )
21
Recalling the memorized channel levels
1.
Press the CHANNEL LEVEL button.
CH.LEVEL
• "CAL " (or "REF 1", etc.) is displayed for several seconds.
• If the channel level mode display disappears, press this
button again.
2.
Select the desired one of REF 1 and REF 2.
TUNE
• Then the channel levels memorized into the selected
preset memory are recalled.