Setting The Speaker Setup - Sherwood RD-606i Instrucciones De Funcionamiento

RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 42

SETTING THE SPEAKER SETUP

• After you have installed this receiver and connected all the components, you should adjust the speaker settings for the
optimum sound acoustics according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should adjust the
speaker settings, too.
SPEAKER SETUP
• SPK(SPEAKER) CONFIGURATION : To select the sizes of the speakers that are connected.
• CROSSOVER : To select the desired crossover frequency.
• SPK(SPEAKER) DISTANCE: To enter the distance between the listening position and each speaker to set the delay time
• RETURN : To return to the previous menu.
When selecting the SPEAKER CONFIGURATION
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the "SPK CONFIG", then press the ENTER button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired speaker.
SPK CONFIG
FRONT : LARGE / SMALL
CENTER : LARGE / SMALL / NO
SURR : LARGE / SMALL / NO
SUB-W : YES / NO
RETURN
CROSSOVER
Fc : 40 / 50 / 80 / 100 / 150 / 200
RETURN
SPK DISTANCE
UNIT : METERS
RETURN
automatically for optimum surround playback.
/ FEET
LEFT : 3.0 m / 0.1 ~ 9.0
CENTER : 3.0 m / 0.1 ~ 9.0
RIGHT : 3.0 m / 0.1 ~ 9.0
SURR R : 3.0 m / 0.1 ~ 9.0
SURR L : 3.0 m / 0.1 ~ 9.0
SUBW : 3.0 m / 0.1 ~ 9.0
RETURN
S P K C O N F
F RON T
42
LEFT : 10.0 ft / 0.5 ~ 30.0
CENTER : 10.0 ft / 0.5 ~ 30.0
RIGHT : 10.0 ft / 0.5 ~ 30.0
SURR R : 10.0 ft / 0.5 ~ 30.0
SURR L : 10.0 ft / 0.5 ~ 30.0
SUBW : 10.0 ft / 0.5 ~ 30.0
RETURN
AT
I G 3 0
: L A RGE