Sherwood RD-606i Instrucciones De Funcionamiento página 47

RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 47
Memorizing the adjusted channel levels
• You can memorize the adjusted channel levels into preset
memory("REF 1", "REF 2") and recall the memorized
whenever you want.
1.
After performing the steps 1 ~ 3 in "Adjusting the
current channel level" procedure on page 46,
press the ENTER button.
CH L V
M O D E
• Then "1" of "REF 1" indication flickers.
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired preset memory,
then press the ENTER button.
• Each time the CURSOR LEFT(◀) or RIGHT(▶) button is
pressed, "REF 1" or "REF 2" is selected.
• The adjusted channel levels have now been memorized
into the selected memory.
AT
L S T E U P 3 0
: R E F1
Recalling the memorized channel levels
1.
Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the "MODE ~ ".
CH L V L S T
M O D E
• "CAL" may be displayed instead of "REF 1" or "REF 2".
2.
Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired one of REF 1 and
REF 2.
• Then the channel levels memorized into the selected
preset memory are recalled.
47
AT
E U P 3 0
: C A L