Engine Oil Change - Honda WH15XT Manual De Explicaciones

ENGINE OIL CHANGE

Drain the oil while the engine is warm to assure rapid and complete
draining.
Do not run the pump without priming water. Dry operation will burn the
seal.
1.Place a suitable container below the engine to catch the used oil, and
then remove the oil filler cap, drain plug, and sealing washer.
2.Allow the used oil to drain completely, and then reinstall the drain
plug and a new sealing washer. Tighten the plug securely.
Improper disposal of engine oil can be harmful to the environment.
If you change your own oil, please dispose of the used oil properly.
Put it in a sealed container, and take it to a recycling center. Do not
discard it in a trash bin, dump it on the ground, or pour it down the
drain.
3.With the engine in a level position, fill with the recommended oil (see
page 36) to the upper limit of the oil filler neck.
Maximum oil capacity: WH15XT: 0.56 L (0.59 US qt, 0.49 Imp qt)
4.Reinstall the oil filler cap securely.
Wash your hands with soap and water after handling used oil.
OIL FILLER NECK
OIL FILLER CAP
WH20XT: 0.58 L (0.61 US qt, 0.51 Imp qt)
SEALING WASHER
(Replace)
OIL DRAIN PLUG
SERVICING YOUR PUMP
OIL FILLER CAP
UPPER LIMIT
35