Removal Of Clogging; Replacing The Collection Bag; Safekeeping; Technical Data - Grizzly ELS 2614 E Manual De Instrucciones

GB
oughly. In this way, you avoid the gen-
eration of mold and unpleasant odours.
• Free the outlet area from possible
shredded residues.

Removal of clogging

Leaf material and fresh plant parts may
clog / block the device.
Cleaning the air outlet area:
1. Remove the collection bag.
2. Clean the external outlet area on the
device.
3. Set the operating mode selector switch
to the suction symbol.
4. Remove dirt residues in the inner air
outlet area with a bottle brush or simi-
lar. Remove unwieldy objects with a
blunt tool without sharp edges.
Cleaning the blower/suction tube and
impeller wheel:
1. Remove the 4 tube-fastening screws
(see picture 1, no. 3a+3b) and pull off
both parts of the blower/suction tube
(see picture 1, no. 2a+2b).
2. Clean the inside of the two-piece blow-
er/suction tube.
3. Carefully remove dirt residues on the
impeller wheel with a bottle brush or
similar and remove bulky objects with
a blunt not sharp tool.
4. Check whether the impeller wheel
turns easily and is in fault-free condi-
tion. Have a defective impeller wheel
replaced by an authorised customer
service centre.
5. Refit the blower/suction tube and
screw it in place.

Replacing the collection bag

Replace a defective collection bag. Em-
ploy only original collection bags (see
126
"Spare Parts"), otherwise the guarantee
claim is invalid.

Safekeeping

• Keep the foliage vacuum in a dry, frost-
free location, which is inaccessible to
children.
• Do not store the device in direct sun-
light; store it in dark or in reduced light
conditions.
• Do not cover the device with nylon
bags, since moisture can form.
• Clean the device thoroughly at the
season end and for storage during
wintering. Clean the collection bag by
removing it, emptying it and washing
with warm water and neutral soap. Re-
attach the dried bag again.
• Ensure that all nuts, bolts and screws
are tightened so the equipment is in
safe, functional condition.

Technical Data

Foliage vacuum .................
Rated input voltage.........230-240V~, 50Hz
Idling speed .................. 8000-14000 min
Input power ................................... 2600 W
Safety class ......................................
Protection category........................... IP 20
Air capacity .......................max. 14 m
Air speed .................... max. 160-270 km/h
Shredding rate ...........................max. 1:10
Content of the collection bag ...............40 l
Weight .......................................ca. 3.4 kg
Sound pressure level
(L ) ............... 92 dB(A); K
pA
Sound power level (L
measured .. 102.8 dB(A); K
guaranteed ........................... 106 dB(A)
Vibration (a ) .......... 4.268 m/s
n
ELS 2614 E
/min
3
= 3.0 dB(A)
pA
)
WA
=2.07 dB(A)
wA
; K=1.5 m/s
2
-1
/ II
2