Cleaning; General Maintenance; Removal Of Clogging And Blockage; Storage - Grizzly ELS 3027 E Traducción Del Manual De Instrucciones Original

The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or sol-
vents. You may otherwise irreparably
damage the appliance.

General maintenance

• Prior to every use, check the appliance
for obvious defects such as loose,
worn or damaged parts.
Check that the screws in the cutting
disk are tight.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Removal of clogging and
blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
Pull out the mains plug!
There is a risk of injury!
1. Remove the protective cover (7) and/
or the suction tube (17).
2. Carefully remove residues or clogging
materials from the impeller wheel.
3. Check to make sure the impeller wheel
is easier to turn and is in undamaged
condition. Have our Service Centre
replace a defective impeller wheel.
4. Retighten the protective cover (7) and/
or the suction tube (17).
If the protective cover (7) and/
or the suction tube (17) is not
correctly screwed into place by
hand, it is not possible to operate
the device.

Storage

• For storage purposes you can remove
the blow tube (
tube ( 17) and the catcher (
from the motor housing (
corresponding installation instructions
in the „Start-up" section).
• Store the device in a dry place well out
of reach of children.
Disposal and protection
of the environment
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Machines do not belong with
domestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implement-
ed. Ask our Service-Center for details.
• Defective units returned to us will be
disposed of for free.
• Throw the cut grass on the compost.
Do not throw it in the normal house-
hold waste.
GB
9) and/or the suction
14)
1) (see the
77