Operating Panel; Description Of Functions - Suntec Wellness Klimatronic ENERGIC 9.0 + Manual Del Usuario

OPERATING PANEL

DESCRIPTION OF FUNCTIONS

1. [POWER]
Press this switch to switch on or off
1. [FUNC]
Press this switch to select between the functions "Cooling", „Heating" or „Dehumidity"
2. [TEMP+]
Press this switch in the cooling function in order to set the required room temperature by 1°C respectively
up to a maximum temperature of 30°C.
Press this switch in the heating function in order to set the required room temperature by 1°C respectively
up to a maximum temperature of 25°C
4. [TEMP-]
Press this switch in the cooling function in order to set the required room temperature by 1°C respectively
up to a minimum temperature of 17°C.
Press this switch in the heating function in order to set the required room temperature by 1°C respectively
up to a minimum temperature of 15°C
5. LED-DISPLAY
The display shows the required target temperature in operation.
By pressing the [TEMP+] or [TEMP-] switch, the current ambient temperature is briefly displayed. When
pressing the [TIMER] switch, the number of hours is briefly shown until activation or deactivation. In the
dehumification function, „dH"(or „HP" upside-down) is shown in the display. Error messages are also
shown in the display.
6. [SPEED]
Press this switch to set the ventilation speed to„LOW", „MID" (middle), „HI" (high) or „AUTO" (automatic). If
„AUTO" is selected, the ventilator operates at temperature differences larger than 9 degrees at top speed.
If the temperature reduces to a difference smaller than 4 degrees, the ventilator switches to middle blower
position. If the temperature reduces further until the target temperature, the ventilator switches to the
lowest blower position.
7. [TIMER]
Programmable time switch with start and residual time
Starting time: This function is used to switch on the ENERGIC unit automatically when the time entered
has expired. Proceed as follows:
a) Press [TIMER] switch in Stand-by (ENERGIC unit is connected but not in operation), to enter the
required number of hours after which the ENERGIC unit is to start.
b) Select the required function (cooling, heating, dehumification) and set the required temperature.
c) When the set number of hours has expired, theENERGIC unit starts automatically.
18