X-lander X-MOVE Manual Del Usuario página 10

up out of the locking devices (2) (a). Fold the locks by pushing the open part down as
shown in picture (b).
16 F I T T I N G T H E C A R S E AT
In order to fit the car seat open the adapter locks by pulling them upwards until they
click open (picture a). Place the additional adapters in the locking devices of the chassis
(picture b) and push the car seat until the locks have clicked into place.
re using the attached car seat you need to ensure that it is properly fitted into place.
17 R E M OV I N G T H E C A R S E AT
To remove the car seat press the notch-unlocking buttons (1) on both sides of the car
seat at the same time pulling it up out of the locking devices (a). Pull the additional
adapters out of the locking devices (b). Fold the locks by pushing the open part down as
shown in picture (c).
18 L E D L I G H T E N I N G
The LED lightening is placed on the stroller frame, the switch is located on the stroller
frame in the place shown in figure. The place for the power batteries is in the bottom
part of the footrest. To install the LR 44 batteries, unscrew the bolt shown in figure and
remove the cover. The right battery assembly is presented on the cover.
19 A D J U S T I N G T H E S A F E T Y H A R N E S S
The length adjusting device is on the back side of the seat unit backrest (a). To loosen
the straps press the device button and pull the safety harness (b). To tighten the straps
pull the strap coming out of the device (c).
20 S H O U L D E R B E LT A D J U S T M E N T
The height of the shoulder belt position may be adjusted based on the child's height.
To change the position, insert the regulator through appropriate holes located in the
reclining seat.
21 B U C K L E
To fasten the belt buckle, slide the belt lock into the slot and press it down until it snaps
into place (b). Repeat this procedure for all locks. To unfasten, press the round button
until the moment when the locks are released from the buckle latch (a).
22 I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
23 A S S E M B L I N G A N D R E M OV I N G T H E H O O D
To mount the hood, slide the end plastic elements through the fence (a). To remove the
hood, press the locking element and slide from the fence (b)
24 AT TAC H I N G T H E C OV E R
To attach the cover, slide the cover bottom part over the footrest and then pull it under
the armrest. Fasten the velcro straps together (a) and fasten the snap fasteners to the
stroller's frame (b).
25 A D J U S T I N G T H E H A N D L E H E I G H T
Press the button in the central part of the handle and adjust its height by pulling or
pushing it towards/away from you.
26 S TO R I N G T H E C H A S S I S
When folded the chassis is free standing in a vertical position. To stand it set the length
of the handle in the position marked on the handle bar with white lines (1) and lock the
folding device in place to prevent the chassis from opening (2). The chassis must be
kept in a place inaccessible to children.
8
Caution: Befo-