Publicidad
Idiomas disponibles
Idiomas disponibles
8. Connect electrical to spoiler.
9. Prefit spoiler to vehicle ensuring holes are accurate and
spoiler will fit flush to fascia. See Figure 4.
NOTE: Test fit is important. Oversized holes may be
required for proper fit.
FIGURE 4
ENSURE PROPER FIT
10. Remove spoiler, remove tape cover at tinnerman clips and
ends of part. Make sure fascia is clean with alcohol and dry
for adhesion.
11. Install spoiler and fasten nuts to 4 Nm torque.
12. Apply light pressure over tail lamps and ends of the spoiler
to ensure proper adhesion of tape.
GMX245 Corvette Spoiler
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
PART NO.
REV 10SE07
INSTALLATION INSTRUCTIONS
DR
TITLE
GMX245 Corvette Spoiler
PART NO.
19157723
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19157723
SHEET
2
SHEET
2
6
OF
6
OF
Publicidad
