Doro congress 205 Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Caution
The earpiece of the handset may attract small ferromagnetic objects such as staples
and pins, care should be taken when placing the handset near these items.
This device is intended for the analogue telephone network lines in AT, BE, BG, CH,
CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT, LU, MT, NL,
NO, PL, PT, RO, SI, SK, SE.
The mains adapter is the disconnect device between the product and mains power.
The mains socket outlet must be close to the equipment and easily accessible.
Batteries
The telephone requires 3 x AAA 1.5V alkaline batteries. When the batteries are
running low
will be displayed.
The batteries will maintain the telephones functions for a few days and prevent the
loss of Caller ID, memories and other functions in the event of a power failure.
1. Check that the mains adapter is correctly connected to avoid losing stored
information.
2. Disconnect the telephone line cord from the network wall socket.
3. Remove the battery cover by pressing a small screwdriver (up to Ø 2.5mm) or
similar into the hole to the side of the battery cover.
4. Install the batteries ensuring that the correct battery polarity is observed.
5. Replace the battery cover.
Connection/Initial programming
1. Connect the curly cord to the handset and to the socket marked
underside of the telephone.
2. Place the handset into the cradle.
3. Connect the mains adapter to the DC 9V socket on the underside of the
underside of he telephone, and an electrical wall socket.
4. The display will now flash the alarm setting.
5. If the alarm is not shown press and hold
6. Press
.
0
7. Select the required language using
8. Select the desired contrast setting (3=normal) using
9. Set the correct hour (00-23) using
10. Set the correct minute/s using
11. Set the correct day using
12. Set the correct month using
13. Select the required pause setting (2 seconds=normal) using
14. Please refer to Batteries above regarding the installation of back up batteries.
15. Connect the telephone line cord to the socket marked
to a telephone network wall socket.
16. Lift the handset and listen for the dial tone. Your telephone is now operational.
English
v
/
. Press
v
V
/
. Press
v
V
/
. Press
v
V
/
. Press
.
v
V
0
/
. Press
v
V
0
4
until the alarm setting flashes.
.
0
/
. Press
v
V
.
0
.
0
.
/
v
on the telephone, and
T
on the
q
.
0
. Press
.
V
0

Publicidad

Tabla de contenido
loading

Tabla de contenido