Important - Amana BX 518 VW VE Manual Del Propietário

1. Tape doors on top right and left corners to prevent
doors from opening unexpectedly.
2. Slide appliance cart under side of refrigerator opposite
hinges.
3. Wrap refrigerator with blanket or pad. Thread strap
around refrigerator. Put foam shipping pads, located in
shipping carton, under strap. Tighten strap securely.
Do not overtighten strap.
4. Lower appliance cart to floor with appliance cart
handles on bottom.
5. Remove top two bolts from skid.
6. Return refrigerator and appliance cart to an upright
position. Remove strap.
7. Slide appliance cart under opposite side of refrigerator.
8. Repeat steps 3-5.
9. Remove wooden base.
10. Return refrigerator and appliance cart to an upright
position. Move refrigerator in front of final location and
remove appliance cart.
2. Remove and reverse doors if necessary.
Some installations may require door reversal to achieve full
door swing. To reverse door swing direction perform the
following steps:
Tools Required
Wrenches and drivers as applicable
Phillips screwdriver
Blade screwdriver
Masking tape
IMPORTANT: For plug removal requiring use of flat blade
screwdriver or putty knife, blade of tool must be covered
with masking tape to avoid damage to refrigerator
finish. For plugs using a screwdriver or nut driver style
head, use appropriate tool to avoid damage to plugs.
1. Remove refrigerator handle.
• Remove handle screw (C) from top handle trim (A) .
Pry up edge of handle trim (A) using blade
screwdriver with blade covered with masking tape.
Remove handle (B) from door by removing 1
remaining mounting screw (C) at each end of handle.
• Remove 1 plug from top hinge side of door and 2
from front hinge side of door (D) . Replace 3 plugs in
empty mounting holes.opposite side of door using
mounting screws (C) .
A
C
B
A
2.
3.
4.
5.
6.
7.
8.
9.
D
3
Remove freezer door handle.
• Open freezer door 90°. Locate two notches on back
(A)
of freezer handle . Insert flat screwdriver driver
blade wrapped in masking tape. Pry up back edge of
(B)
handle cap and remove from handle.
(A)
• Remove handle from door by removing two
mounting screws (C) .
(D)
• Remove 2 plugs from opposite side of freezer
door and replace in empty mounting holes.
B
C
A
Remove top hinge cover. Top hinge cover snaps off.
Remove 5 / " screws (A) to release top hinge (B) and
16
hinge shim (C) using hex nut driver. Remove and retain
all shims (C & D) .
Remove refrigerator door by lifting door off of center
hinge pin (F) and hex nut (E) . Inspect door to verify all
shims (D) are with hinge pin.
Remove center hinge pin (F) using hex nut driver. Due
to tight fit of pin, firm pressure may need to be applied.
Remove and retain all shims (D) .
Remove freezer door by lifting door off bottom
hinge (K) .
Remove center hinge bracket (G) and shim (H) using
Phillips screwdriver.
Remove toe grille and bottom hinge cover. Both snap
off.
Remove bottom hinge pin (J), bottom hinge (K) , and
hinge shims (L) using hex nut driver. Remove and
retain shims (D) .
A
B
I
E
F
G
I
J
K
M
D
C
D
H
D
L