Haier HA10TG31SS Manual Del Usuario página 11

DOOR ALIGNMENT CONT.
REINSTALLATION
1. Remove the lower pivot pin from the lower
hinge by turning counter clockwise. Move the
pin to the opposite hole and tighten. (see below)
(Fig. 3 and Fig. 4)
Fig. 3
bottom
of unit
bottom hinge
2. Tilt refrigerator on a 45-degree angle to have
access to the bottom front.
CAUTION
Two People Required.
3. Remove both left and right front feet from
bottom.
4. Loosen the screws holding the bottom hinge
and remove it.
5. Align the holes in the bottom hinge to the
corresponding holes on the opposite side of the
cabinet. Insert and tighten the screws. Reinstall
both front feet.
6. To install refrigerator door: Line up the left
bottom hole of the refrigerator compartment
door over the bottom hinge pin. Move door
forward to make it straight and align with
central hinge. Install the central hinge again, and
turn the hinge axle until it completely enters the
door body. Secure it with the screws provided.
(see g. 4)
NOTE: Remove plugs from doorframe and install
Fig. 4
lower pivot pin
doorstopper
(left side)
7. To install freezer door: Line up left bottom
hole of the door over the central hinge middle
pin. Move door forward to make it straight and
align with freezer compartment. Place over left
side the top hinge, align holes with hole on the
refrigerator top and tighten with the screws
provided.
PAGE 9 SET UP & USE
on other side.
middle
pivot pin
screw
holes
central
hinge