Features And Use - Haier HA10TG31SS Manual Del Usuario

FEATURES AND USE

ADJUSTABLE TEMPERATURE DIAL
Your refrigerator will automatically maintain the
temperature level you select. The temperature
control has 7 settings . COLD is the warmest
setting. COLDER is the coldest
Unplugging the unit stops the cooling in both the
refrigeration and freezer sections.
dial to the 4th indicator marking (middle setting),
and allow 24 hours to pass before adjusting the
temperature to your needs.
To adjust the temperature range in the cold
setting, turn the temperature dial in a clockwise
direction. For normal operating conditions, keep
the dial halfway between cold and coldest. For
your convenience, the factory presets the control
at normal operating conditions.
NOTE: If the refrigerator has been placed in a
horizontal or tilted position for any period of time
wait 24 hours before plugging the unit in.
FREEZER SECTION
Your freezer compartment is equipped with
adjustable air ow control. For your convenience,
air ow is preset by the factory to the colder
setting. There is also an option to adjust the
settings, either to cold or to coldest.
REFRIGERATOR SECTION
INTERIOR LIGHT
Your refrigerator is equipped with an interior light
in the fresh food section for you to easily locate
your food.
FROST- FREE REFRIGERATOR-FREEZER
You should never need to defrost your freezer, as
it automatically defrosts any ice build-up that may
occur.
setting
.
At rst, set the
Mechanical Devices to Defrost Refrigertor or
Freezer. Do not Puncture Refrigerant Tubing.
REFRIGERATOR INTERIOR SHELVES
(Shelves may vary by model)
The shelves of your refrigerator were designed
with you in mind. Their varied adjustability allows
you to satisfy your personal storage needs.
To remove or adjust a full-width slide-out shelf:
(see g. 5)
1. Gently tilt the shelf up and slide forward until the
2. To replace the shelf, select the desired setting
PAGE 10 SET UP & USE
DANGER—
Risk of Fire or Explosion.
Flammable Refrigerant Used. Do Not Use
shelf has been completely removed.
and gently slide the shelf back until it rests in the
locking position.
Fig. 5