Wachs SP-669 Manual Del Usuario página 12

( Fig.7)
3. Axial and radial directional decals provided
on feed screws indicate turning rotation. ( Fig.7)
4. WINDOW CUTTING SEQUENCE--HORIZONTAL
Follow the cutting direction and sequence diagram
to cut a window in the pipe wall.( Fig. 8a)
3
CUT
.
1
CUT
(fig. 8a) WINDOW CUTTING SEQUENCE (HORIZONTAL)
4. WINDOW CUTTING SEQUENCE--VERTICAL
Follow the cutting direction and sequence diagram
to cut a window in the pipe wall.( Fig. 8b)
(fig. 8b) WINDOW CUTTING SEQUENCE (VERTICAL)
WINDOW CUTTER
2
CUT
4
CUT
CUT 4
CUT 3
CUT 1
CUT 2
VI. AXIAL OR RADIAL CUTTING
PROCEDURES:
1. Under power, verify blade rotation direction.
2. Once proper blade rotation has been assured, lock all four
locking screws and lower the blade by rotating the feed nut
counter clockwise. Utilize the provided 1-3/8" open ended
wrench.
3. As soon as contact is made with the pipe surface, stop
feeding.
4. Set depth stop ( Fig. 9). Lower depth stop so that it is the
same distance above the feed nut as the distance from the
O.D. to the I.D. of the pipe being cut. Lock the depth stop
in place using the provided hex key set. (Detail A fig. 9)
5. With the depth stop set, begin to feed the blade down into
the pipe.
Fig. 9
6. Adjust locking screws. To make axial cuts, radial
locking screws should be locked. To make radial
cuts, the axial locking screws should be locked.
7. To feed axially, refer to the decal on the axial feed
screw cover. ( Fig. 10 )
Fig. 10
8. To feed radially, refer to decal on the radial feed screw
cover. ( Fig. 11 )
12.
A