Wachs SP-669 Manual Del Usuario página 13

Fig. 11
VI.CHANGING CUTTER DIRECTION:
NOTE: Once mounted, the cutter blade need not be
removed to change cutting direction.
1. Raise the cutter blade out of the pipe and disengage power
supply.
2. Loosen center nut on cutter head using the provided 1-3/
8" open ended wrench. ( Fig. 12 )
Fig. 12
WINDOW CUTTER
3. Rotate the head 90° and tighten the center nut.
4. Loosen all locking set screws and position cutter blade
over the " Cut Line ".
5. Tighten the appropriate locking set screws. Radial screws
for axial cut, axial screws for radial cut. ( Fig. 13 )
Fig. 13
6. Engage the power supply and verify blade rotation direc-
tion.
NOTE: Direction of blade rotation should be opposite the
7. Begin the cut.
8. Repeat these procedures until the window is complete.
13.
direction of axial machine travel. ( Conventional
milling )