Tabla de contenido
Publicidad
ENGLISH
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool along with the
date code:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
Using an extension cable
Always use an approved extension cable suitable for the
u
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defec-
tive. When using a cable reel, always unwind the cable
completely. Use of an extension cable not suitable for the
power input of the tool or which is damaged or defective
may result in a risk of fire and electric shock.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-on button
3. Variable speed control knob
4. Dust extraction outlet
5. Sanding disc
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
6
(Original instructions)
Fitting the sanding disc (fig.A)
Place the tool on a table, with the spindle facing up.
u
Place the sanding disc (5) onto the spindle.
u
Secure the sanding disc using the screws (6).
u
Fitting sanding sheets (fig. B)
Warning! Never use the tool without a sanding sheet or ac-
cessory in place.
Press the sheet firmly and evenly onto the sanding disc
u
(5), making sure that the holes in the sheet line up with the
holes in the base.
Fitting and removing the dustbag (fig. C)
Fit the dustbag (7) over the dust extraction outlet (4).
u
To remove the dustbag, pull it off the dust extraction outlet.
u
Connecting a vacuum cleaner (fig. D)
Insert the hose (8) of the vacuum cleaner into the dust
u
extraction outlet (4).
Use
Warning! Let the tool work at its own pace. Do not overload.
Variable speed control
The variable speed control allows you to adapt the speed of
the tool to the workpiece material.
Set the control knob (3) to the desired setting. Use a high
u
speed for wood, medium speed for veneer and synthetics
and low speed for acrylic glass, non-ferrous metals and for
removing paints.
Switching on and off
To switch the tool on, press the on/off switch (1).
u
For continuous operation, press the lock-on button (2) and
u
release the on/off switch.
To switch the tool off, release the on/off switch. To switch
u
the tool off when in continuous operation, press the on/off
switch once more and release it.
Automatic brake system
This feature keeps the speed of the disc limited as long as
the tool does not touch the workpiece. As soon as the tool is
placed on the workpiece, the disc will reach its normal operat-
ing speed.
Emptying the dustbag
The dustbag should be emptied every 10 minutes.
Shake the dustbag to empty the contents.
u
Hints for optimum use (fig. E)
Do not exert too much pressure on the tool.
u
Publicidad
Tabla de contenido
