Electrical Safety - Black and Decker KFBES410 Manual De Instrucciones

página de 109

/ 109
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Keep hands away from cutting area. Never reach



underneath the work piece any reason. Do not insert

ﬁ ngers or thumb into the vicinity of the reciprocating blade

and blade clamp. Do not stabilize the saw by gripping

the shoe.

Keep blades sharp. Dull or damaged blades may cause



the saw to swerve or stall under pressure. Always use

the appropriate type of saw blade for the workpiece

material and type of cut.

When cutting pipe or conduit, make sure that they are



free from water, electrical wiring, etc.

Do not touch the workpiece or the blade immediately



after operating the tool. They can become very hot.

Be aware of hidden hazards, before cutting into walls,



ﬂ oors or ceilings, check for the location of wiring and

pipes.

The blade will continue to move after releasing



the switch. Always switch the tool off and wait for the

saw blade to come to a complete standstill before putting

the tool down.

Warning! Contact with, or inhalation of dusts arising from

cutting applications may endanger the health of the operator

and possible bystanders. Wear a dust mask speciﬁ cally

designed for protection against dust and fumes and ensure

that persons within or entering the work area are also

protected.

The intended use is described in this instruction manual.



The use of any accessory or attachment or performance

of any operation with this tool other than those

recommended in this instruction manual may present

a risk of personal injury and/or damage to property.

Safety of others

This appliance is not intended for use by persons



(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning use of the appliance by a person responsible

for their safety.

Children should be supervised to ensure that they do not



play with the appliance.

Residual risks.

Additional residual risks may arise when using the tool

which may not be included in the enclosed safety warnings.

These risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations

and the implementation of safety devices, certain residual

risks can not be avoided. These include:

Injuries caused by touching any rotating/moving parts.



Injuries caused when changing any parts, blades or



accessories.

(Original instructions)

Injuries caused by prolonged use of a tool. When using



any tool for prolonged periods ensure you take regular

breaks.

Impairment of hearing.



Health hazards caused by breathing dust developed when



using your tool (example:- working with wood, especially

oak, beech and MDF.)

Vibration

The declared vibration emission values stated in the technical

data and the declaration of conformity have been measured

in accordance with a standard test method provided by

EN 60745 and may be used for comparing one tool with

another. The declared vibration emission value may also be

used in a preliminary assessment of exposure.

Warning! The vibration emission value during actual use

of the power tool can differ from the declared value depending

on the ways in which the tool is used. The vibration level may

increase above the level stated.

When assessing vibration exposure to determine safety

measures required by 2002/44/EC to protect persons regularly

using power tools in employment, an estimation of vibration

exposure should consider, the actual conditions of use and the

way the tool is used, including taking account of all parts of the

operating cycle such as the times when the tool is switched off

and when it is running idle in addition to the trigger time.

Labels on tool

The following pictograms are shown on the tool along with

the date code:

Warning! To reduce the risk of injury, the user

must read the instruction manual.