Troubleshooting And Maintenance - Sanus LF228 Manual Del Usuario

5-7
Adjust level
[32]
6
Manage Cables
1
[03]
3

Troubleshooting and Maintenance

To remove the TV: (See illustrations in step 4.)
1. Unscrew the locking screw [22].
2. Push to release the locking tab (L).
3. Carefully lift the TV from the arm [03].
TV will not hold the downward tilt position and fl oats upward:
1. Adjust tilt tension setting (see step 5-4).
2. If the problem persists, use a bracket installation option that
uses longer spacers (see step 1-4).
6901-002114 <03>
[03]
1. Fully extend the arm [03]. Remove cable covers (C).
2. Install the cable tie clips [29] and ties [30] into the bottom of the arm, as shown.
(C)
[01]
[03]
Loosen screws. Adjust level. Re-tighten. screws
2
[29]
3. Pull each arm to its full extension then route the cables through
the arm, leaving enough slack to prevent stretching the cables
when the arm is moved.
4. Reattach covers (C).
4
(C)
TV will not hold the home position and fl oats downward:
1. Adjust tilt tension setting (see step 5-4).
2. If the problem persists, use a bracket installation option that
uses shorter spacers (see step 1-4).
[32]
[30]
[29]
[03]
13