Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and able to
support the fan, you are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through opening in
hanging bracket and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the hanging
bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder in
place and to lift the fan up to you once you are set on the ladder.
Continue to the "Wiring" section for wiring diagram.

6. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
WARNING: If using this fan in a DAMP location,
this fan must be connected to a supply circuit
that is protected by a Ground Fault Circuit
Interrupter (GFCI) to reduce the risk of personal
injury, electrical shock or death.
When downrod is secured in place on the
hanging bracket, electrical wiring can be made as
follows:
Connect BLACK wire from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
Since this fan does not come with a light kit, you
will need to cap off the BLUE wire with a wire
connector (as shown with arrow in diagram).
[Note: If you elect to purchase a light kit for the
fan, the BLUE wire from the fan must be
connected to the BLACK wire from the ceiling
instead.]
All manuals and user guides at all-guides.com
page 5
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote
control sold separately).
hanging bracket tab
hanging ball slot
ground
(green or bare)
ground
(green
or bare)
*

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Ellington tah52cs5Ellington tah52mww5

Tabla de contenido