Cequent Performance Products 24950 Instrucciones De Instalación página 5

4. Remove drain plugs – using a utility knife, carefully cut the caulking
around the (2) rearmost drain plugs in trunk pan. Remove drain
plugs and return to vehicle owner.
7. Install top plates and fasteners – gently pull fascia down and
install Top Plates with 4-1/2" long carriage bolts on top of bumper
beam extensions.
NOTE: The bolt location varies by model year .
See figures 3 and 4 for correct top plate bolt location.
©2016 Cequent™ Performance Products, Inc. -
Fig.3
2017-current models
Fig.4
2009 – 2016 models
Printed in Mexico
5. If present, temporarily move hands-free trunk release cable from fascia
near area to be trimmed.
Trim fascia - using a tape measure, marker, and utility knife, cut a notch in
6.
the lower part of fascia, approximately 3-1/4" wide x 3" deep, centered on
vehicle as shown in figure 2.
Note: Obtain vehicle owner's permission before trimming fascia.
3-1/4"
8. Hitch installation - raise hitch into position aligning slots in hitch
with carriage bolts and loosely install the (4) flanged locknuts onto
carriage bolts, (2) per side.
Sheet 5 of 18 24950NP
4-1/2"
9-7-16 Rev. A