Motorola Solutions IMPRES PMMN4067 Guia Del Usuario página 5

OPERATION
This procedure must be carried out before entering
hazardous environment.
Attaching the RSM to the Radio
1. Turn the radio off.
2. Remove the universal connector seal from the side of
the radio and attach the RSM.
3. Turn the radio on.
Wearing the RSM
(See Figure 2)
For optimum performance from your RSM, wear the radio
and RSM so that the accessory cord will not cross over or
touch the antenna. Also, try to wear the radio and
accessory combination fairly close to each other to avoid
strain on the accessory connector.
IMPORTANT NOTE:
The RSM must be fitted only with the ATEX approved clip/stud (part no.
4205823V07). Standard non-ATEX approved (metal) clips must not be used.
3