Sony MDR-RF5000K Manual De Instrucciones página 11

Ocultar thumbs Ver también para MDR-RF5000K:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
Rest the headphones on the transmitter so that the headphones' contact
point meets the transmitter's contact pin, and make sure that the CHG
indicator lights up.
It takes approx. 3 hours to fully charge the battery (the CHG indicator goes off
when charging is complete).
When placing the headphones on the transmitter, be sure to hold them with both
hands so that the right and left housings are horizontal, and place the
headphones vertically on the transmitter. The charging lever is pushed down and
the contact pin comes up. When the transmitter's contact pin meets the
headphones' contact point, the CHG indicator lights up.
If the CHG indicator is not lit
• Be sure to close the battery compartment lid. The battery charge function is not
activated when the lid is not fully closed.
• Check if the right and left headphones are rested on the transmitter correctly.
• The indicator will not light up if the headphones' contact point does not meet the
transmitter's contact pin. In this case, remove the headphones and place them on
the transmitter again so that the indicator lights up.
• Make sure that the supplied rechargeable nickel-metal hydride battery is installed
in the battery compartment. Dry batteries cannot be charged.
• If the rechargeable battery is damaged or the 3 and # of the battery do not match
those in the battery compartment correctly, the CHG indicator blinks.
Contact
point
Charging
lever
Contact pin
Right
housing
CHG
indicator
Left housing
Preparation
(Continued)
GB
11

Publicidad

Tabla de contenido
loading

Tabla de contenido