Clean Your Coffeemaker Before Using The First Time; Setting The Clock And Delay Brew Time - Mr Coffee CJX Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CLEAN YOUR COFFEEMAKER BEFORE USING THE FIRST TIME

Make sure your first cup of coffee is as good as can be by cleaning your MR. COFFEE
Coffeemaker before its first use. Just follow these simple steps:
1. Wash the decanter, decanter lid and the filter basket in a mixture of mild detergent
and water. Rinse each thoroughly (please refer to the Parts Diagram).
2. Replace all the parts and close the lid. Then, run a brew cycle with water only,
without adding coffee and coffee filter.
3. When brewing is complete, turn your coffeemaker off, discard the water in the
decanter and rinse the decanter, decanter lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
8

SETTING THE CLOCK AND DELAY BREW TIME

®
To Set the Clock:
1. Plug the power cord into a standard electrical
outlet. The clock will flash on the control panel
to indicate that the time has not been set yet.
2. Press and hold the HOUR and MINUTE buttons until
you reach the current time. The AM or PM indicator
is at the left of the display (Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the clock
will cause the clock to start keeping time from
12:00 a.m. You must set the clock if you want to
use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply press
the SET DELAY button (Figure 3) and, while the
DELAY BREW yellow light is flashing, set the brew
time by pressing the HOUR and MINUTE buttons
(Figure 4). The AM or PM indicator is at the left of
the clock display.
Within a few seconds the display will change
to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle, see the
Brewing Coffee Later section. In the event of a power
outage, if you have selected any of the operating
functions, your coffeemaker will automatically
revert to the last operation selected if the power
is restored within 10 seconds.
To check the programmed time, push the SET
DELAY button. The display will show the time you
have programmed the coffee to brew. If you press
the SET DELAY button again or wait a few seconds,
the display will switch back.
F
1
IGURE
F
2
IGURE
F
3
IGURE
F
4
IGURE
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido