Electrical Safety - Black and Decker CS3651LC Manual De Instrucciones

Under extreme conditions, battery leakage may occur.
u
When you notice liquid on the batteries carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
u
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs
seek medical attention. In case of eye contact, rinse
immediately with clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your BLACK+DECKER charger only to charge
u
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be placed in a well
u
ventilated area when charging.
The charger is intended for indoor use only.
Read the instruction manual before use.
w
Fail safe isolating transformer. The mains
supply is electrically separated from the
transformer output.
(Original instructions)
x
The charger automatically shuts off if the
ambient temperature becomes too high. As a
consequence the charger will be inoperable.
The unit must be disconnected from the
mains supply and taken to an authorised
service centre for repair.

Electrical safety

#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by
u
the manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Forward/reverse slider
3. Bit holder
4. LED work light
5. Charger
6. Charger plug
7. Charging connector
Assembly
Fitting and removing a drill bit or a screwdriver
bit (fig. B)
This tool uses screwdriver bits and drill bits with a 6.35
mm (1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
u
To remove a bit, pull the bit shaft out of the bit holder
u
(3).
Note: The right angled attachment shown in fig. E-J may
not be included with your tool.
ENGLISH
7