To Assemble The Tube And Handle On The Product :580Bfs Mark; To Adjust The Harness - Husqvarna 580BTS Mark III Manual De Usuario

5. Attach the intermediate pipe to the control pipe.
6. Attach the blower nozzle to the intermediate pipe.
To assemble the tube and handle on
the product :580BFS Mark III
1. Attach the flexible tube (A) to the pipe angle with the
clamp (C).
E
B
2. Push the handle (E) onto the control pipe (B)
.
1667 - 002 - 19.04.2021
C
A
D
F
G
3. Attach and tighten the bolt, washer and nuts as
shown in the illustration.
4. Attach the control pipe (B) to the flexible tube (A)
with the clamp (D). Make sure that the mark on the
control pipe is up.
5. Attach the intermediate pipe (F) to the control pipe.
6. Attach the blower nozzle (G) to the intermediate
pipe.
7. Loosen the knob (H) to adjust the position of the
handle.
8. Tighten the knob again.

To adjust the harness

A correctly adjusted harness and product makes
operation easier.
1. Put on the harness of the product.
H
11