Safety Instructions For Maintenance; To Assemble The Blower Pipe And The Control Handle On The Product; Assembly - Husqvarna 350BT Manual Del Usuario

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the blower pipe and the
control handle on the product
Note: Lubricate the tubes and flexible hose to make
them easier to assemble.
1. Attach the flexible hose (A) to the pipe angle and the
control pipe (B) with the clamps (C) and (D).
C
6

Assembly

A
D
B
• Stop the engine, remove the spark plug and let the
engine become cool before maintenance and
assembly.
• A blocked spark arrestor screen causes the engine
to become too hot which causes damage to the
engine.
2. Attach the handle holder (E) to the control pipe. Align
the handle holder with the flange on the control pipe.
350BT
350BF
3. Adjust the position and angle of the control handle to
a safe and correct work position. Tighten the knob.
4. For 350BT: Attach the cable to the flexible hose with
the cable clamp.
E
E
1246 - 001 - 14.02.2020