Making The Electrical Connections - AirPro Progress Lighting P250062 Manual De Instalación

Washer
Hanger
bracket
Wood
screw
Safety cable
Canopy
Figure 9
Step 4. Place the downrod ball int
b racket socket (Fig.9). Make sure the hanger
ball is seated in the groove on the hanger bracket.
Drive a wood screw and washers into the side of
the brace that holds the outlet box. Leave 3mm
(1/8") of space between the support brace and the
washer. Insert the safety cable through the hanger
bracket and one of the holes in the outlet box into
the ceiling. Adjust the length of the safety cable to
reach the screw and washers by pulling the extra
cable through the cable clamp until the overall
length is correct, put the end of the cable back
through the cable clamp,forming a loop at the end
of the cable. Tighten the cable clamp securely.
Now, put the loop in the end of the safety cable
over the wood screw and under the washer.
Tighten the wood screw securely.(Figure 9)
Making the Electrical
Connections
Spring washer
NOTE
TO AVOID POSSIBLE ELECTRICAL SHOCK, BE
SURE ELECTRICITY IS TURNED OFF AT THE
MAIN FUSE BOX BEFORE WIRING.
Downrod
NOTE
ball
FAN MUST BE INSTALLED AT A MAXIMUM
DISTANCE
TRANSMITTING
SIGNAL TRANSMISSION BETWEEN THE
o the hanger
TRANSMITTING UNIT AND THE FAN'S
RECEIVING UNIT.
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
EMI Filter
Figure 10
OF 20 FEET FROM THE
UNIT FOR PROPER
Hanger
bracket
Connect green wires from EMI Filter and related
parts according to the wiring diagram as shown in
Figure 11, make sure EMI Filter is properly seated
in outlet box.
AC IN L(Black)
AC IN N(White)
Ground wire
Ground wire
Ground wire
Ground wire
Ground wire
Gray
Yellow
Red
Gray
Red
Yellow
Ground wire
Figure 11
1. (Figure 10) Place the EMI filter into the ceiling
box before installing the receiver into the bracket.
Insert the receiver into the mounting bracket with
the flat side of the receiver facing the ceiling.
2. (Figure 11) Motor to receiver electrical
connections: Connect the grey wire from the
fan to grey wire from the receiver. Connect
the red wire from the fan to the red wire from
the receiver. Connect the yellow wire from the
fan to the yellow wire from the receiver. Connect
the blue wire from the fan to the blue wire from
the receiver. Connect the white wire from the fan
to the white wire from the receiver.
wire connections with the plastic wire connecting
nuts provided.
White
Blue
Blue
White
Secure the
6.