Attaching The Fan Blades - AirPro Progress Lighting P250007 Manual De Instalación

Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling
canopy with the two screws in the
mounting plate. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws firmly.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by
aligning the ring's slots with the screws in
the canopy. Rotate the ring clockwise to
lock in place.
4. You may now proceed to attaching the
fan blades.
Attaching the Fan
Blades
NOTE: Your fan blades are reversible.
Select the blade side finish which best
accentuates your decor.
1. Attach blade to blade bracket using
the screws as shown in figure 13.
Start a screw into the bracket. Repeat
for the two remaining screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the
motor by inserting the alignment
post into the slot on the bottom of
the motor and tightening the motor
screws. Please note that the motor
screws are pre-attached into the blade
brackets (Figure 14).
4. Repeat steps 1,2 and 3 for the
remaining blades.
Screws
Slot
Alignment Post
Screws
Blade Arm
Blade
Figure 13
Figure 14
8.