Finishing The Installation - AirPro Progress Lighting P250063 Manual De Instalación

Finishing the Installation

Step 1. After wire connections, take the motor
assembly off the hook.Raise the motor assembly
up to the ceiling bracket assembly.Align two
remained screws on the motor assembly to the
keyholes on the ceiling bracket assembly, rotate
clockwise until the screw heads engage the
keyhole slots fully. Make sure not to break any
wire connections (Figure 8).
Step 2. Re-install two mounting screws to the
round holes, securely tighten four (4) mounting
screws (Figure 9).
Step 3. Lift the trim ring up, aligning four
notches on the canopy of motor assembly with
raised areas on the inner side of trim ring and
pop it into the canopy (Figure 10).
Figure 8
Mounting screws
Motor assembly
Figure 9
Ceiling bracket
assembly
Canopy
Motor assembly
Figure 10
Trim ring
Motor assembly
6.