Frequently Asked Questions - Kodak P811 Guia Del Usuario

Output file formats
Resolution (fixed)
Memory Cards
Interfaces
USB
USB Mass Storage Supported
Power Input 100-240V AC, 50/60 Hz, Output 5V, 1A
Takes four AAA (UM-4) batteries (not included). Recommend rechargeable batteries for optimal
Batteries number of scans. Rechargeable battery life in 600dpi averages 100+ scans per charge. Actual battery
life may vary based on usage.
Photo feeding
Film feeding
Dimensions
Net weight
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
F r e q u e n t l y A s k e d Q u e s t i o n s
Q: There are strange lines on the scanned picture, or the picture is not clear.
A: Check the following:
 Are there scratches on the original, or is the original clean? Remove any stains or dust from the original before scanning.
 Did you insert your original into the plastic sheath before scanning?
 Has the scanner been used for a long period of time without cleaning and calibration? Follow the instructions for "Cleaning
the scanner" on page 20 and "Calibrating the scanner" on page 21, and then try again.
Q: The scanned filmstrip image is not rotating properly
The current "auxiliary" OCR capability has difficulty distinguishing the direction of some numbers, (i.e.,"6", "9"). If the number's
A:
position is near the edge of the film, it can easily be worn out or damaged, and then it can't be detected in the expected
position, or meet the required conditions causing the Auto Mirror/Flip function to be disabled (see page 12). Please follow the
indicator on the film adapter to re-scan the filmstrip.
Q: Can I scan a slide film?
A: If you want to scan mounted positive slides, the mount must be removed before scanning. Pry the mount open from its sides
and be careful not to damage the slide inside.
 Once the mount is removed, you may need to consult your local photo studio to revert it to the original status or fit a
new one.
Q: The original is stuck halfway in the feed slot.
A: Press the Power button; the scanner ejects photos out the front, and films are ejected out the back.
Q: The status indicator blinks rapidly, no scan is possible, or the scanner powers off automatically.
A: Check the following:
 Is the memory card inserted properly into the memory card slot? Re-insert the card and try again.
 Is the SD card locked (set to write-protect)? Unlock the card.
 Is the memory card full? The indicator blinks when the free space on the memory card is below 1MB. Use another card if
necessary.
 Make sure the memory cards are in FAT or FAT32 file formats only, not NTFS or any other file format. Reformat the
memory card if necessary to use it with the scanner.
22 Customer Support: http://www.pandigital.net/kodaksupport
All manuals and user guides at all-guides.com
JPEG with compression (4:2:2)
Photo: 600 x 600 (default) and 300 x 300 dpi
Film: 1200 x 1200 dpi,
Refer to Supported Memory Cards (pg 9)
Mini USB port compatible USB 2.0
WINDOWS XP, WINDOWS VISTA, WINDOWS 7
Sheet-fed type (single-pass)
Negative Filmstrip - fed type (35mm film adapter required)
2" (L)x10.5" (W)x1-3/4" (H)
56 mm (L) x 269 mm (W) x 44 (H) mm
14 oz. (391.2g)
o
15ºC ~ 35ºC (59 F~95
20% RH ~ 70% RH
o
-20ºC ~ 60ºC (59 F~95
10% RH ~ 90% RH
o
F);
o
F)