Uline H-308 Guia De Inicio Rapido

H-308, H-309
INDUSTRIAL
PLIER STAPLER
17
10
5
2
4
H-309
CAUTION! Read instructions carefully before
operating plier, and save them for future
reference.
TO LOAD:
1. Pull up and out until
magazine cover is open
as far as it will go.
(See Figure 1)
2. Squeeze plier closed and
insert staple stick through
loading guide (rear end
first). (See Figure 2)
3. Let front end of stick
drop in. Be sure it drops
in completely. Push
magazine cover closed
until you hear a click
which indicates it is
completely closed.
(See Figure 3)
NOTE: Staples required: S-1480 or S-1481.
WARNING! Keep fingers away from staple
discharge area when operating or when
clearing a jam.
NOTE: H-309 contains pointed blade. Use extra
care when handling.
PAGE 1 OF 3
1-800-295-5510
uline.com
6 13 11 1 12 7
3
2 15 16
Figure 1
Figure 2
Figure 3
PARTS
14
# DESCRIPTION
1 Driver Arm
2 Clincher Arm
3 Operating Lever
4 Magazine
5 Core
8 9
6 Pusher
7 Pusher Spring
8 Retainer
9 Pivot Pin
LOADING
TO CLEAR A JAM:
Grasp plier as if ready to staple. Insert a pencil or similar
object between clincher arm and magazine, away from
staple discharge area. Operate plier once or twice to
expel jammed staples.
NOTE: Do not pry with screwdriver or similar
tool as damage to magazine may occur.
TO DISASSEMBLE:
• Remove lever pin and operating lever.
• Remove loading guide by squeezing in on sides.
• Remove magazine cover by disengaging front from
pusher and then pulling it out.
• Squeeze driver tips together with pliers until
disengaged from driver arm.
• Swing driver arm open and remove drive bearings.
• Remove magazine spring from clincher arm spring.
• Disengage front tabs of clincher arm spring from
clincher arm. Remove clincher arm spring. Push
retainer rear leg out from under magazine. Lift out
assembly of core, pusher, pusher spring and retainer.
WARNING! Do not disassemble core assembly,
as compressed pusher spring and retainer may
fly off, causing eye injury.
Para Español, vea página 2.
Pour le français, consulter la page 3.
# DESCRIPTION
10 Driver
11 Clincher Arm Spring
12 Magazine Spring
13 Drive Bearing
14 Magazine Cover
15 Lever Pin
16 E-Ring
17 Loading Guide
0421 IH-308