While Operating Machine - Tennant 1510 Manual De Operador Y Lista De Repuestos

NOTE: The brush, solution and drive will start when
the control grips are rotated forward.
FIG. 10
6. To operate the machine in reverse, simply rotate
the control grips backwards. The brush base will
automatically lift off the floor when reversing.
7. To stop the machine, position the machine on a
level surface and gradually release the control
grips.
8. After cleaning, perform the Daily Maintenance
procedures (See MACHINE MAINTENANCE).

WHILE OPERATING MACHINE

WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
1. Overlap each cleaning path by 50 mm (2 in).
2. Use a collapsing rectangle pattern when cleaning
large rooms (Figure 11).
FIG. 11
3. Periodically observe the recovery tank for
excessive foam buildup. Pour a recommended
foam control solution into the recovery tank to
breakdown foam.
ATTENTION: Do not allow foam or water to enter
float shut-off screen, vacuum motor damage will
result; not covered by warranty. Foam will not
activate the float shut-off screen.
Tennant 1510 (05- -03)
Home Find... Go To..
4. For excessive heavily soiled areas, use the double
scrub switch function (Brush/Solution symbols).
5. If the cleaning path leaves streaks, clean or
replace the spray tips (See MACHINE
MAINTENANCE).
6. When cleaning on inclines, always clean moving
downward, never upward. Never climb inclines
that exceed 5 degrees, machine damage may
occur.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
7. Observe the battery meter. When the needle
nears the left side red zone, stop cleaning and
recharge the batteries (Figure 12).
ATTENTION: Do not operate machine with the
battery meter needle in the red zone, battery
damage will result.
FIG. 12
8. Observe the clear hose at the rear of the machine
for remaining solution (Figure 13). The hose has
15 liter increment markings printed on it. 15 liters
of solution will last approximately 4 minutes. When
the solution tank runs dry, put the machine in the
travel mode and transport to the dumping site.
FIG. 13
OPERATION
11