Set Defaults; Host Type Selection; Keyboard Wedge Host Type - Symbol ORG LS 9208 Manual Del Usuario

Q u i c k
Programming Bar Codes
The following are some frequently used programming bar codes.
Tip: For additional host types, refer to the LS 9208 Product
Reference Guide,
9208 CD or visit the Symbol Website
http://www.symbol.com/manuals.

Set Defaults

Scanning this bar code sets all parameters to their factory default
values
.

Host Type Selection

If you are using a Synapse cable (i.e., part number STIxx-xxxx),
the scanner autodetects the type of host you are using, so you do
not need to scan host type selection bar codes.
If you are using a USB interface, the scanner autodetects the USB
and defaults to the HID keyboard interface. See page 80 to select
the IBM Hand-Held host type. Refer to the LS 9208 Product
Reference Guide,
If you are using a Keyboard Wedge, RS-232, Wand Emulation, or
IBM 46XX host, you must select that host type from the
programming bar codes that follow.

Keyboard Wedge Host Type

R e f e r e n c e
p/n
SET DEFAULTS
p/n 72-60833-xx, for additional USB host types.
IBM PC/AT & IBM PC Compatibles
73
72-60833-xx, available on the LS