Mitsubishi Electric PAC-SC30GRA Libro De Instrucciones página 16

2 Select the unit
(1) Select the unit to be registered in the group selected with 1.
• The address numbers will change in the sequence shown below within the temperature setting
display area whenever the
" " "
• The address numbers will change in the opposite direction when the
Temperature setting display area: Address number displayed
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
(2) Selecting registered units
• The following display will be shown when the selected unit is registered in one of the eight groups
controlled by this equipment.
Example: When unit 011 is called out with group 3
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
3 To register units in groups
(1) Register the selected units in groups
• Press the TEST RUN switch with the group number and unit address selected with 1 and 2
displayed.
• This operation completes the registration task.
• [ ] or unit type will be displayed if registration was performed normally. [
unit type if the registration was not performed normally.
Display the address number that is to be registered
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
(2) Registering other units
• The subsequent address will be displayed when the
after registration is complete. Repeat procedures 2 and 3 to continue with registration.
NOTE: Registration is required not only for indoor units but when you want to set the remote controller
and slave system controller as well. Registration of multiple groups is possible only at the system
controller address.
16
temperature setting switch is pressed.
" " "
• •
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
Cursor blinks. Indicates that the unit is registered in group 6 in this case.
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
Each controller
" "
• •
[ ] or unit type will be displayed if
registration was performed normally
Registration complete screen. Indoor unit with an
address number of 006 is registered in group 3.
temperature setting switch is pressed
Indoor unit:
Remote controller:
System controller:
Indoor unit:
Remote controller:
System controller:
switch is pressed.
] will blink beside the
IC
RC
SC
001 to 050
101 to 200
201 to 250