Technical Data; Noise/Vibration Information; Filling The Magazine - KMR 3426 Manual Del Usuario

4 I English
1

TECHNICAL DATA

Type
Dimensions mm
Weight kg (without fasteners)
Contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity No. of fasteners
Penetration depth setting
Fastener: Staples G
Staple length mm
Wire thickness mm
Staple width mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2

NOISE/VIBRATION INFORMATION

Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level L
WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
SUPPLIED WITH
3
1 Stapler
1 Tool use and safety instructions
1 Technical data sheet
KMR
4
3426
Only those fasteners specified under technical data
(see 1) may be used.
280/345
When filling the magazine, hold the tool so that the
2,2 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5 - 8.5 bar/
yoke or trigger depressed.
0.5 - 0.85 MPa
Pull the pusher (62A) back until it locks. Using the strip
8.5 bar/
of staples push aside the magazine covering (52) and
0.85 MP
insert the staples. Finally release the pusher and slide
2.7 l at 6
it manually towards the staples.
bar / 0.6 MPa
140
5
yes
The penetration depth of the nail head can be
controlled by means of the air pressure. If this is
25 - 50
not satisfactory, the penetration setting offers a
1.4 x 1.65
more accurate adjustment of the penetration depth.
11.7
Adjustment is only possible in the unpressurized
condition.
The penetration depth setting can be moved by one
9 4420
or more notches by loosening the screw (44) and the
68 3868
safety yoke (43). For safety reasons, this should only
be carried out in a depressurised state.
Retighten the screw.
6
3426
Balancer for 20-30 N (2.0-3.0 Kp),
83.9 dB(A)
cable travel 2.0 m (6.5 ft)
96.9 dB(A)
3,15 m/s2

FILLING THE MAGAZINE

FIL PENETRATION DEPTH SETTING
ACCESSORIES
3426
Code No.
40 3407